First Start

1. Connecting to the Built-in Access Point

On first power-up (or after a network settings reset), the device creates its own WiFi network:

• SSID: scalior-slc-XXXXXX (last characters are a unique MAC-based suffix)
• Password: printed in the manual
• IP address: 192.168.10.1

After connecting to the network, the configuration web interface will open automatically. If it does not, open 192.168.10.1 in your browser.

---

2. Connecting to Your Home WiFi Network

1. In the web interface, go to Network → Wi-Fi.
2. In the Available Networks block, find your home network. If your network is not listed, make sure it is active and restart the controller (Settings → System & Update → Restart Controller).
3. Select your network and enter the password.
4. Click Save.
5. After connecting, the controller's IP address on the home network will appear on the page.

Tip: Assign a static IP to the device in your router settings so the address does not change.

---

3. Initial Configuration

After accessing the web interface, go to Settings and configure the basic parameters:

General Parameters

Parameter	Description
Number of Flights	1–4. One flight is one directional staircase section, triggered by sensors independently of other flights
Number of Steps	Total number of LED steps (1–96)

Parameters per Flight

For each flight (Flight 1 – Flight 4) specify:

Parameter	Description
Name	Custom name displayed in the interface
Steps	Which steps belong to this flight (assigned in the LED Terminals section)
Top / Bottom Sensors	Which sensors (A–H) trigger ignition from top/bottom

After configuring, click Apply (appears when there are unsaved changes).

---

4. Factory Reset

If the device is unreachable or you need to start fresh:

Action	Result
Reset Network Settings	Removes WiFi/MQTT configuration, device creates an access point
Reset Lighting Settings	Returns animation parameters to factory defaults
Full Reset	Removes all settings

Reset buttons are located at Settings → System & Update.